Tuesday, October 31, 2017

DIY Hitch Mounted Vertical Bike Rack/ Cargo Carrier that Does Not Interfere with the Rear Spare Tire


Adding a hitch mounted bike carrier has been a problem on RT’s that are equipped with rear mounted spare tire carrier. I’ve seen many attempts by RT owners to negate this problem, from using hitch extenders to experimenting with different available bike carriers on the market. Clearing the spare tire is only half of the problem. Opening the Sprinter rear doors and lowering the spare tire with a hitch bike carrier mounted either with bikes loaded or unloaded is another huge problem not to mention the added length to the vehicle with the addition of hitch extender.

Friday, October 6, 2017

Installing Coach Battery Powered 12-volt DC sockets on Sprinter Dashboard

My 2011 Agile has two factory 12-volt DC sockets located in the cab, one by the pull-out cup holder (only powered when engine is running) and one just below the pull-out cup holder which is always powered. The MB factory sockets are wired into the chassis battery.

I installed 2 additional 12-volt DC sockets for charging our phones/ tablets/ cameras/etc. I wired the new sockets from the coach battery so as not to put extra drain into the starting battery when we are out dry camping. The additional sockets were installed on the outer sides of the dashboard top vents thus minimizing charging cables clutter hanging from the dashboard and interfering while driving. I opted for 12-volt DC sockets and use plug-in USB car chargers in lieu of surface- mount USB charger sockets for more universal mobile charging approach. Also replacing a malfunctioning USB charger with our setup would be much easier, not so with the surface- mount USB charger sockets.

Saturday, September 9, 2017

Replacing That Smelly Toilet Bowl in a Roadtrek Agile

 
My 2011 Agile came with a Thetford Aqua Magic V toilet which I've replaced twice with same model due to holding tank fume leakage around the flush valve assembly. The last replacement lasted about 2 years of use then it started to leak fumes again! 
 
Thetford Aqua Magic V design is not very well thought-out IMHO; the space between the toilet bowl and the toilet outer casing/base is hollow and open to the black tank. Waste splatter can get stuck in that hollow space during flushing, very unhygienic. The flusher arm seal is also unreliable, it is basically sealed with packed grease. When grease seal starts to dry up, it starts to leak fumes from the holding tank especially when there is negative pressure inside the van like driving with windows open.

Sunday, August 20, 2017

Building a Wooden Shower Mat for the Agile

 
A fellow sprinter forum member made a really nice teak shower mat on his Agile and that got me interested in making one for my RV. Currently, there are no commercially available wooden shower mats for the Agile so you have to make your own if you really wanted one.

Thursday, June 1, 2017

Custom K-Cup Coffee Brewer Station

 The stock 120-volt coffee maker was replaced with  800-watt Aicok Single-Serve K-cup coffee brewer. The Aicok runs off our 1000-watt Magnum Inverter/Charger. There is no initial current draw spike, it consistently pulls around 765 watts (@120 volts) for about 2 minutes (heating an 8-oz. water), then current draw drops to about 4.2 watts with the pump running to  percolate the heated water through the K-cup pod. The brewer automatically shuts-off when brewing cycle is finished. We really like this brewer; it is easy to use, and easy to clean/ maintain. The unit is relatively compact in design measuring about 3.94"W × 8.66"D x 9.45"H. Aicok customer support is also very responsive and helpful, a big plus in my book.
 
The brewer station with built-in slider is made from 1/2" Birch plywood with edge treatment using hardwood stock; it's then stained to match the existing cabinets. To prevent the brewer from sliding out while underway, a Decorite 5838 push latch was used. The clear door and the hinges are made out from Acrylic plastic. A strong magnetic latch holds the door closed, the small cubby is perfect for storing K-cup pods.
 
Amazon link for the Aicok Single-Serve K-cup Coffee Brewer, you'll also find reviews, specs, and  pictures of the brewer in the link provided. Enjoy your coffee!
 
Note: If not for the size limitation, I probably have bought the 700-watt Keurig In Room Coffee Brewer instead. The Keurig In-Room is about 1.6 inches taller than the Aicok and will not work with my setup. I have a 2.5 gallon water holder located under the coffee-maker and the extra height of the Keurig makes it impossible to load/ unload the 2.5 gallon water container into the DIY holder.